shackspace wiki

Benutzer-Werkzeuge

Webseiten-Werkzeuge

Sie befinden sich hier: shackspace Wiki » Friedhof » beta-layout PCB Manufacturing Setup » pcb-pool PCB Printer
Zuletzt angesehen:
friedhof:beta-layout:pcbprinter

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

Link zu dieser Vergleichsansicht

Beide Seiten der vorigen RevisionVorhergehende Überarbeitung
Nächste Überarbeitung		Vorhergehende Überarbeitung
friedhof:beta-layout:pcbprinter [2020-07-20 10:08] – ↷ Seite von project:beta-layout:pcbprinter nach friedhof:beta-layout:pcbprinter verschoben neosfriedhof:beta-layout:pcbprinter [2020-07-20 10:30] (aktuell) – ↷ Links angepasst weil Seiten im Wiki verschoben wurden 192.168.146.218
Zeile 59: Zeile 59:
 ===== Etching ===== ===== Etching =====
 Use your favourite method to etch the board. Use your favourite method to etch the board.
-You might want to check out the [[project:beta-layout:etchbath]] documentation.+You might want to check out the [[friedhof:beta-layout:etchbath]] documentation.
 For fine structures, use Fe3Cl! The ink-based soldermask gets lifted off the copper by NaPS and flakes off way before the etching is done. For fine structures, use Fe3Cl! The ink-based soldermask gets lifted off the copper by NaPS and flakes off way before the etching is done.
  
Zeile 67: Zeile 67:
 It helps if you keep the rest of PCB surface covered in cleaner while you concentrate on another spot -- it will start dissolving the ink and you'll have an easier time rubbing it off when you get to it. It helps if you keep the rest of PCB surface covered in cleaner while you concentrate on another spot -- it will start dissolving the ink and you'll have an easier time rubbing it off when you get to it.
 ===== Chemical tinning ===== ===== Chemical tinning =====
-To prevent the exposed copper from oxidizing (makes soldering difficult and looks crappy) you can tin the whole board.  An easy way to do this is setting up a chemical tinning solution and just drop the cleaned board into the solution for around two (2) minutes.  More details in the [[project:beta-layout:chemical tinning]] documentation.+To prevent the exposed copper from oxidizing (makes soldering difficult and looks crappy) you can tin the whole board.  An easy way to do this is setting up a chemical tinning solution and just drop the cleaned board into the solution for around two (2) minutes.  More details in the [[friedhof:beta-layout:chemical_tinning]] documentation.
  
  
 ====== Further Reading ====== ====== Further Reading ======
-  * [[project:beta-layout:pcbprinter:Experiments]] +  * [[friedhof:beta-layout:pcbprinter:experiments]] 
-  * [[project:beta-layout:pcbprinter:Double-sided printing]] +  * [[friedhof:beta-layout:pcbprinter:double-sided_printing]] 
-  * [[Troubleshooting]] +  * [[friedhof:beta-layout:troubleshooting]] 
-  * [[project:beta-layout:pcbprinter:Dismantling & Cleaning]]+  * [[friedhof:beta-layout:pcbprinter:dismantling_cleaning]]
  
friedhof/beta-layout/pcbprinter.1595232495.txt.gz · Zuletzt geändert: 2020-07-20 10:08 von neos